Harness checker AE-HC100A

Max 100 pin open-short checker
It is possible to check all kinds of harness

  • Being equipped with 2 kinds of mode setting.
    Inspection Mode・・・To perform an inspection by comparing with the saved harness condition
    Search Mode ・・・To display the number of pin being connected by probe.
  • To store the connection state of wire harness for MAX 30 kinds.
  • Operating simply only by connecting with master harness and reading the saved data.
  • Anyone can operate harness inspection simply for the simple and intuitive operation.
  • Being miniaturized and lightened, you do not need to choose the installation site.
  • Operation in field is possible if you use mobile battery as power supply.
Mode Check(AUTO)・Search(pin number manual search)
Pin number for inspection 100pin
Memory 30 kinds of harness data can be saved(non-volatile memory)
Inspection connector MIL 50pin×2
Display section 20digit×4line liquid crystal display with backlight
Quality determination and LED display(green・red)
Operation Right or left cursor key/ESC key/START key
Buzzer NG notice
I/O Tip jack x1 for pin search probe, External control connector x1
Power supply DC5V (with AC adapter),mobile battery sold on the market can also be used
Outer dimension 260(W)×65(H)×180(D)(excluding protruding parts such as rubber legs,etc)
Weight About1.1kg
External signal External output(quality determination output・measurement completion output)
External input(start・stop)
Option Custom-made jig and terminal stand is available (Separate consultation is necessary)
Conduction OK
Applied voltage DC5V・determined voltage above DC2.0V(terminal level)
Conduction NG
Applied voltage DC5V・determined voltage below DC0.8V(terminal level)

※ We will change the specifications of the catalogue without notice by improvement.

Copyright(c) 2014 AEMIC CORPORATION All Rights Reserved.